Econokit is a water doping system for combustion engines. It transforms the humid air into gas to improve the combustion efficiency. The fuel’s combustion consists of a numerous chemical reactions, mostly liquid fuel and Oxygen from the air. Econokit increases on the humidity rate of the induction air and modifies the gas composition.
A diffuser is inserted in the engine air inlet which creates humid air. This humid air then goes through the reactor to heat it up to 250°C, which transforms it into polarized steam. This produced gas is added to the air admitted by the diffuser.
I installed Econokit on my 2001 Twingo, gasoline engine. Since then, my fuel consumption as gone down 23%, my actual consumption is 5.8L/100KM, I’m very pleased.
I consumed on average 13.5 l / 100km, I came down to 11.5l/100km. But what I most appreciated is the gain of engine torque. I was borderline at the level of pollution during the inspection. Now with the Econokit, my vehicle pollutes less.
I drive approximately 60 to 100 km more with a full tank, depending on the kind of road. On the driving level I notice more power, if I go up a hill with several people, the car has no difficulty.
I was able to notice a decrease of consumption of about 5 %. But especially I noticed the disappearance of smokes, and very clear improvement of the performances: more flexibility.
I calculated the average consumption after the installation of the kit, I noticed an economy of about 8%.
What I noticed the most, is the reduction of exhaust gases. I did the test of the white paper towel, put at the exit of the exhaust pipe. After several strong accelerations, it remained practically white.
Dim : H 19cm x W 15cm x D 10cm
The bubbler L in stainless steel is recommended in the installation of Econokit on a vehicle, like a truck, bus, tractor…where there is room to place the bubbler. The bubbler L contains around 1500mL and can be combined with the option « additional bubbler ».
It allows the water to heat up to an ideal temperature between 25 and 45° C. It is advised for the use of Econokit in cold countries in winter.
It must be added and placed on the diffuser in the case of insufficient aspiration in the air admission circuit.
In certain cases, a single bubbler might not provide enough water capacity and it can be necessary to increase the capacity of the system to extend the period between refills. So each bubbler L has a fitting which allows it to be connected to a second bubbler using fittings and hoses in this pack.
Today, Econokit is distributed throughout the world. Our activity is based on a worldwide network of trained and certified partners, with two representation options:
As our brand’s representative, the resellers and distributors can rely on the sharing of information to develop their sales on their territory.